Sealey SA2501 Uživatelský manuál stáhnout pdf

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions

and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,

WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH

IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE

THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY INSTRUCTIONS

 WARNING! Ensure that Health & Safety, local authority, and general workshop practice regulations are

adhered to when using this equipment.

 WARNING!Disconnect from air supply before changing accessories or servicing.

 Maintain the cut-off tool in good condition (use an authorised service agent).

 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will

invalidate the warranty.

 Use in a suitable work area. Keep area free from unrelated materials and ensure that there is adequate lighting.

 Before each use check cutting disc for condition. If worn or damaged replace immediately.

 Ensure that the speed rating (rpm) of the disc is the same as, or greater than, the speed rating of the cut off saw.

 Ensure that there are no flammable or combustible materials near the work area.

 WARNING! Always wear approved eye (or face) and hand protection when operating the cut-off tool.

 Use face, dust, or respiratory protection in accordance with COSHH regulations.

 Depending on the task, the cut-off tool noise level may exceed 98dB in which case wear safety ear defenders.

 Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain and/or tie back long

hair.

 Wear appropriate protective clothing and keep hands and body clear of working parts.

 Maintain correct balance and footing. Ensure that the floor is not slippery and wear non-slip shoes.

 Keep children and unauthorised persons away from the work area.

 Check moving parts alignment on a regular basis.

 Ensure that the workpiece is secure before operating the air cut-off tool. Never hold a workpiece by hand.

 Check the workpiece to ensure there are no protruding screws, bolts, nuts etc.

 Avoid unintentional starting.

 WARNING! Ensure correct air pressure is maintained and not exceeded. Recommended pressure 90psi

 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure

that all connections are secure.

 Prolonged exposure to vibration from this tool poses a health risk. It is the owner’s responsibility to correctly

assess the potential hazard and issue guidelines for safe periods of use and offer suitable protective equipment.

 DO NOT use the cut-off tool for a task it is not designed to perform.

 DO NOT operate cut-off tool if any parts are damaged or missing as this may cause failure and/or personal injury.

 WARNING! DO NOT grind any materials containing asbestos.

 DO NOT carry the cut-off tool by the hose, or yank the hose from the air supply.

 DO NOT force, or apply heavy pressure to, the cut-off tool, let the tool do the work.

 DO NOT place air line attachments close to your face and do not point them at other people or animals.

 DO NOT operate cut-off tool when you are tired or under the influence of alcohol, drugs or intoxicating medication.

 DO NOT use the cut-off tool where there are flammable liquids, solids or gases, such as paint solvents

and including waste wiping or cleaning rags etc.

 DO NOT carry the cut-off tool with your finger on the power lever.

 DO NOT direct air from the air line at yourself or others.

 When not in use disconnect from air supply and store in a safe, dry, childproof location.

DANGER OF FIRE/EXPLOSION HAZARD

 WARNING! The cutting process can produce streams of sparks which are a potential source of

ignition especially when cutting metal.

 DO NOT use the cut-off tool where there are flammable liquids, solids or gases.

 DO NOT allow cut-off tool sparks to make contact with the operator’s clothing or any other fabric

such as cleaning rags. Fabrics contaminated with inflammable materials such as petrol, oil, grease,

paint and solvents are a particular fire hazard.

 To reduce the risk of clothing catching fire the operator should wear wool or cotton outer garments

treated with a fire retardant in preference to man-made fibres.

Original Language Version

SA2501 Issue: 1 -

14/05/13

INSTRUCTIONS FOR:

AIR CUT-OFF 75mm LONG REACH

MODEL No: SA2501

1 2 3 4

Shrnutí obsahu

Strany 1 - MODEL No: SA2501

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly mai

Strany 2 - 3. PREPARING CUT-OFF TOOL

2. INTRODUCTION & SPECIFICATION3.1. Air Supply - Recommended hook-up is shown in fig 2. 3.1.1. Ensure that the cut-off tool air valve (or thro

Strany 3 - 5. MAINTENANCE

 WARNING! Disconnect the tool from the air supply before changing the disc, servicing or performing maintenance. Replace or repair damaged parts.

Strany 4 - Original Language Version

WARNING! – Risk of Hand Arm Vibration Injury.This tool may cause Hand Arm Vibration Syndrome if its use is not adequately managed.This tool is subject

Příbuzné modely SA673

Komentáře k této Příručce

Žádné komentáře

Samsung PPM42S3 Instrukcja Użytkownika (52 strony)

Marka: Samsung | Kategoria: TVs & monitors | Rozmiar: 5.72 MB |

Spis treści

MONITOR DE PLASMA

(PLASMA DISPLAY PANEL )

Informações FCC

Instruções ao Usuário

Instruções de segurança

Acessórios Fornecidos

◆ INTRODUÇÃO

Índice(continuação)

O Seu Novo Monitor de Plasma

Montando a Base Suporte

Peças de Montagem

Notas de Instalação

(continuação)

Conectando os Alto-Falantes

Núcleos de Ferrite

Selecionando o Idioma

Mudando o Modo da Imagem

(Modo PC ou DVI)

Congelamento da Imagem Atual

Mudando o Modo de Som

Ajustes Adicionais de Som

Evitando a Queima da Tela

Ajustando a Tela Múltipla

Exibindo a Informação do PC

Ligando o Ventilador

Ajustando o Modo Filme

Ouvindo o Som da Imagem PIP

Parte Traseira do Monitor

Conectando à Entrada RGB (PC)

Conectando à Entrada DVI

Configuração dos Pinos

Modo de Entrada (PC/DVI)

Cuidados e Manutenção

Especificações Técnicas

Anotações

ELECTRONICS

Więcej produktów i instrukcji dla Telewizory i monitory Samsung

Modele	Rodzaj dokumentu
NX30	Podręcznik Samsung NX30 Benutzerhandbuch, 218 strony
1100PPLUS	Instrukcja Użytkownika Samsung 1100PPLUS Manual de usuario, 59 strony
ED55C	Instrukcja Użytkownika Samsung ED46C Manuel utilisateur, 147 strony
SAMSUNG PL170	Instrukcja Użytkownika Samsung SAMSUNG PL170 صارف دستی, 126 strony
DIGIMAX 4500 SUPER	Instrukcja Użytkownika Samsung DIGIMAX V4 Manual de usuario, 140 strony
S27E510C	Instrukcja Użytkownika Samsung S27E510C User manual, 96 strony
S19A100N	Instrukcja Użytkownika Samsung S19A100N Handleiding [pt] , 36 strony
920NW	Instrukcja Użytkownika Samsung 920NW User manual, 47 strony
SL46B	Instrukcja Użytkownika Samsung SL46B Benutzerhandbuch [bs] [hr] , 221 strony
NC221	Instrukcja Użytkownika Samsung NC221 دليل المستخدم [sk] , 112 strony
G19P	Instrukcja Użytkownika Samsung G19P ユーザーマニュアル, 43 strony
FX2490HD	Instrukcja Użytkownika Samsung FX2490HD Handleiding, 91 strony
SAMSUNG PL170	Instrukcja Użytkownika Samsung SAMSUNG PL170 Посібник користувача, 127 strony
2494HS	Instrukcja Użytkownika Samsung 2494HM Посібник користувача, 100 strony
225UW	Instrukcja Użytkownika Samsung 225UW Manuel utilisateur [en] [sk] , 62 strony
SMX-C20BP	Instrukcja Użytkownika Samsung SMX-C24BP User manual, 121 strony
LA32C630K1R	Instrukcja Użytkownika Samsung LA32C630K1R صارف گائیڈ [da] , 46 strony
S24C450F	Instrukcja Użytkownika Samsung S24C450F User manual [ja] [zh] , 104 strony
P2470HD	Instrukcja Użytkownika Samsung P2470HD Упътване за употреба, 78 strony
P2050	Instrukcja Użytkownika Samsung P2050 Εγχειρίδιο ιδιοκτήτη, 48 strony