Sealey VS8626 Uživatelský manuál stáhnout pdf (Strana 3)

Original Language Version

VS8626Issue:2-29/12/11

3.2. Filter Replace

3.2.1. PresstheFunctionbuttontoselecttheappropriatesystem

(There is a full list of systems on the rear of the tool).

3.2.2. Press Mode button to select correct type (Filter Replace).

3.2.3. Press the ‘OK’ button to perform the function.

3.2.4. Oncethefunctionhascompleted,theModeLEDwillashto

indicate a successful reset.

3.2.5. If the function is unsuccessful, the 3 System Selection LEDs

  willash.

3.3. Additive Reset

3.3.1. PresstheFunctionbuttontoselecttheappropriatesystem

(There is a full list of systems on the rear of the tool).

3.3.2. Press Mode button to select correct type (Additive Reset).

3.3.3. Press the ‘OK’ button to perform the function.

3.3.4. Oncethefunctionhascompleted,theModeLEDwillash

to indicate a successful reset.

3.3.5. If the function is unsuccessful, the 3 System Selection LEDs

  willash.

3.3.6. Disconnecttester,openllercapformorethan5seconds,

then close again.

3.4. Regenerate Filter

3.4.1. Startthevehicle’sengineandallowittowarmup.

3.4.2. PresstheFunctionbuttontoselecttheappropriatesystem

(There is a full list of systems on the rear of the tool).

3.4.3. PressModebuttontoselectcorrecttype(RegenerateFilter).

3.4.4. Pressthe‘OK’buttontoperformthefunction.

3.4.5. Oncethefunctionhascompleted,theModeLEDwillashto

indicate a successful reset.

3.4.6. Ifthefunctionisunsuccessful,the3SystemSelectionLEDs

  willash.

3.4.7. Switchtheignitionoff,unplugthetoolandturnignitionon.

NOTE: Regenerationtakesaround15minsintotal(2minsrunning

 atidle,8minsat4000rpmandthen5minsatidle).Ensure

 thatrear/exhaustareaofthevehicleiskeptclearofpeople

for this period.

Filter Replace

Additive Reset

Regenerate Filter

Note: As part of the process, a clear codes message will be sent to the vehicle (any faults that are permanent on

 thevehiclewillremainuntilthefaultisxed).

(See list on reverse)

1 2 3 4

Komentáře k této Příručce

Žádné komentáře

Sealey VS8626 Uživatelský manuál Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Sealey VS8626