Sealey DFS55 Uživatelský manuál stáhnout pdf

1.2 WORKSHOP/ENVIRONMENTAL SAFETY

 WARNING! Ensure that all relevant Health and Safety, Local

Authority, Control of Substances Hazardous to Health

(COSHH) and General Workshop Practice Regulations are

strictly adhered to when using this equipment.

 Ensure there are no flammable or combustible materials near

the work area.

 Locate dust free vacuum system in a suitable work area.

Keep area clean and tidy and free from unrelated materials.

Ensure there is adequate lighting.

 DO NOT get the dust free vacuum system wet or use in

damp or wet locations.

 Dispose of waste products in accordance with local authority

regulations.

1.3 MAINTENANCE SAFETY

 WARNING!Disconnect dust free vacuum system from mains

power and air supply before changing accessories, servicing

or performing maintenance.

 Maintain the dust free vacuum system in good condition (use

an authorised service agent).

 Replace or repair damaged parts. Use recommended parts

only. Unauthorised parts may be dangerous and will

invalidate the warranty.

1.4 AIR SAFETY

 WARNING! Ensure correct air pressure is used, maintained,

and not exceeded for the sander attachment.

 The air supply should be adequate for a minimum of 10.6cfm

free air delivery to the sanding tool. There should be a

minimum of 13cfm free air delivered to the air inlet of the

dust free vacuum system. We recommend the use of a 3HP

(or more) compressor.

 Air supply must be delivered through a 3/8” internal diameter

air hose. If you use a 5/16” internal diameter the

performance of the tool may suffer.

 Keep air hose away from heat, oil and sharp edges. Check

air hose for wear before each use, and ensure that all

connections are secure.

 Before each use check attached tool for condition. If worn or

damaged replace immediately.

 WARNING! Ensure you turn off the air supply before

detaching the air hose from the vacuum system.

 When not in use ensure that the air supply is turned off.

1.5 OPERATOR SAFETY

 WARNING! Always wear appropriate approved eye, face,

mask, ear defenders, or protective clothing according to task

being undertaken.

1. SAFETY INSTRUCTIONS

INSTRUCTIONS FOR: COMBINATION dusT

free/WeT & drY VACuuM sYsTeM AIr/

eLeCTrIC 55LTr MODEL NO: DFS55

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and

properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND

CAUTIONS. USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO

MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.

1.1. ELECTRICAL SAFETY.  WARNING! It is the user’s

responsibility to read, understand and comply with the

following:

You must check all electrical equipment and appliances to

ensure they are safe before using. You must inspect power

supply leads, plugs and all electrical connections for wear and

damage. You must ensure the risk of electric shock is

minimised by the installation of appropriate safety devices. An

RCCB (Residual Current Circuit Breaker) should be

incorporated in the main distribution board. We also

recommend that an RCD (Residual Current Device) is used

with all electrical products. It is particularly important to use an

RCD with portable products that are plugged into an electrical

supply not protected by an RCCB. If in doubt consult a

qualified electrician. You may obtain a Residual Current

Device by contacting your Sealey dealer. You must also read

and understand the following instructions concerning electrical

safety.

1.1.1. The Electricity At Work Act 1989 requires all portable

electrical appliances, if used on business premises, to be

tested by a qualified electrician, using a Portable Appliance

Tester (PAT), at least once a year.

1.1.2. The Health & Safety at Work Act 1974 makes owners of

electrical appliances responsible for the safe condition of the

appliance and the safety of the appliance operator. If in any

doubt about electrical safety, contact a qualified electrician.

1.1.3. Ensure the insulation on all cables and the product itself is

safe before connecting to the mains power supply. See 1.1.1.

& 1.1.2. above and use a Portable Appliance Tester (PAT).

1.1.4. Ensure that cables are always protected against short circuit and

overload.

1.1.5. Regularly inspect power supply, leads, plugs for wear and

damage and all electrical connections to ensure that none is

loose.

1.1.6. Important: Ensure the voltage marked on the product is the

same as the electrical power supply to be used, and check

that plugs are fitted with the correct capacity fuse. A 13 amp

plug may require a fuse smaller than 13 amps for certain

products, see fuse rating above.

1.1.7. DO NOT pull or carry the appliance by its power supply lead.

1.1.8. DO NOT pull power plug from socket by the power cable.

1.1.9. DO NOT use worn or damaged leads, plugs or connections.

Immediately replace or have repaired by a qualified electrician.

A U.K. 3 pin plug with ASTA/BS approval is fitted. In case of

damage, cut off and fit a new plug according to the following

instructions (discard old plug safely). (UK only - see

diagram above).

Ensure the unit is correctly earthed via a three-pin plug.

a) Connect the green/yellow earth wire to the earth

terminal ‘E’.

b) Connect the brown live wire to live terminal ‘L’.

c) Connect the blue neutral wire to the neutral terminal ‘N’.

d) After wiring, check that there are no bare wires, that all

wires have been correctly connected, that the cable outer

insulation extends beyond the cable restraint and that the

restraint is tight.

Double insulated products are fitted with live (BROWN) and

neutral (BLUE) wires only. Double insulated products are

always marked with this symbol. To re-wire, connect the

brown and blue wires as indicated above. DO NOT

connect the brown or blue to the earth terminal.

1.1.10. Some products require more than a 13 amp electrical supply.

In such a case, NO plug will be fitted. You must contact

a qualified electrician to ensure a 30 amp fused supply is

available. We recommend you discuss the installation of an

industrial round pin

plug and socket with

your electrician.

1.1.11. Cable extension

reels. When a cable

extension reel is used

it should be fully

unwound before

connection. A cable

reel with an RCD

fitted is recommended

since any product

which is plugged into

the cable reel will be

protected. The section

of the cores of the

cable is important and should be at least 1.5mm², but to be

absolutely sure that the capacity of the cable reel is suitable

for this product and for others that may be used in the other

output sockets, we recommend the use of 2.5mm² section

cable.

FUSE RATING

THIS PRODUCT MUST BE FITTED WITH A

13 AMP FUSE

Yellow & Green

Earth Wire

Cable

Restraint

Brown

Live

Wire

Blue

Neutral

Wire

Original Language Version

DFS55 Issue: 2 - 17/02/10

1 2 3 4 5

Shrnutí obsahu

Strany 1 - COMBINATION dusT

1.2 WORKSHOP/ENVIRONMENTAL SAFETY WARNING! Ensure that all relevant Health and Safety, Local Authority, Control of Substances Hazardous to Healt

Strany 2 - Original Language Version

2. INTRODUCTION & SPECIFICATIONManufactured from tough composite material suitable for use for industrial and bodyshop use. Microchip controlled

Strany 3 - 5. AIR SUPPLY

6.1 Connecting an Air operated tool. IMPORTANT: See section 4 for details of external air supply system.6.1.1 FIT THE FINE PARTICLE FILTER. (fi

Strany 4 - MAINTENANCE

7 . OPERATING INSTRUCTIONS WARNING! Ensure you have read and understood and adhere to Section 1 safety instruction. DO NOT vacuum hazardous

Strany 5 - TROUBLESHOOTING

Cartridge Filter .........Model No. DFS55.02-42Fine Particle Filter .........Model No. DFS55.04Dust Col

Komentáře k této Příručce

Žádné komentáře

Sealey DFS55 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Nástroje Sealey DFS55. Sealey DFS55 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Nástroje Sealey DFS55